Residencial Marine big and small
For pleasure craft we have developed separate high -frequency ultrasonic transducers that are glued on the hull inside the boat.
We charge 11 meters underwater ship per transducer, if the underwater ship is longer than 11 meters, a second transducer will be added, and so we continue with the calculation according to the length of the boat.
The transducers are connected to a control box that controls it.
The control box can be placed anywhere, usually we will look at how we walk with the cables and so we determine the location of the box.
This control box needs 230V (shore power) via a power supply to work, but no worries, since it always has to be on if you are ashore, the transducer only uses 6 watts, which is very little.
There is also a possibility to work via a power distributor that can switch between 12V-24V and 230V, if there is not always shore current in the port or at the landing place.
If it switches to the battery, there is also a safety in it that switches off the device when the voltage drops below 11.8V, this to prevent the device from emptying the battery.
We also always supply the special glue that must be used to glue the transducers, other glue is completely out of the question, since our glue lets through the high -frequency ultrasonic, and other gluing blocks it so that the installation does not work.
The installation is easy to place yourself, when that happens we can do the inspection in order to grant your warranty.
We can also equip the propeller shaft with a tow contact to keep your screw clean.
This is a separate installation separate from the transducers that we use for your hull.
Questions?
No problem.
We are happy to help you further.